Structure and foundation inspection basics for the exam

Structural questions on the national home inspector exam usually describe something you can see from a basement, crawlspace, attic or the outside of the house, then ask what it suggests or how to report it. You are not asked to design or engineer anything. You are asked to tell normal conditions from warning signs and to know when a structural engineer or other specialist should take a closer look. This guide walks through the main ideas in plain language.

Stay inside a visual, non-invasive inspection

Inspectors look at the structure where it is readily visible and safely reachable. They do not remove finishes, dig beside footings or calculate loads. Much of the structure is hidden behind drywall, under floors or below grade, so a strong report says what was seen, what could not be seen and why. When a question hints at a hidden problem, the best answer usually reports the visible clue, notes the limitation and recommends further evaluation.

Foundations and footings

Common foundation types include poured concrete walls, concrete block walls, slab-on-grade and piers. Footings spread the weight of the house into the soil and are rarely visible. Learn to read cracks by their pattern rather than their mere presence:

Floors, walls and framing

Know the load path in simple terms: the roof and floors rest on walls and beams, which rest on posts and the foundation. Clues worth reporting include sagging or springy floors, notched or cut joists, beams resting on too little bearing, posts that are leaning or rotted at the base, and doors that stick or rack in their frames. A joist cut through for a pipe or duct is a classic exam item; the safe answer reports the cut and recommends evaluation and repair by a qualified contractor.

Crawlspaces and basements

These spaces show a lot about the structure and moisture. Look for standing water, damp soil without a vapor barrier, efflorescence (white mineral deposits) on masonry, wood rot, insect damage and inadequate ventilation where vents are used. Moisture problems often start outside, so pair what you see underneath with grading, gutters and downspouts around the house.

Moisture, rot and wood-destroying insects

Water is the most common cause of structural decay. Watch for wood in contact with soil, soft or darkened framing, mud tubes on foundation walls and staining below plumbing or bathrooms. A general inspector reports these conditions and recommends evaluation by the right specialist, such as a licensed pest control professional, rather than naming the insect or estimating hidden damage.

How to report structural findings

A clear note names the component, its location, the condition, why it matters and who should look further. For example: "Horizontal crack with inward bowing at the north basement wall; possible soil pressure; recommend evaluation by a licensed structural engineer." That structure matches the reporting and professional-practice parts of the outline, so it pairs well with the exam tips and the practice test guide.

A short study loop for structure topics

  1. Read the structure study guide once from start to finish.
  2. Answer a set of structure practice questions and write one sentence in your own words for each miss.
  3. Review crack patterns and moisture clues again, then take a mixed set so structural items appear among other systems.
  4. Fold structure days into the 30-day study plan, and compare with the roof basics guide the plumbing basics guide and the exterior and site basics guide.

FAQ: structure and foundation inspection basics for the exam

Is every foundation crack a defect?

No. Thin shrinkage cracks are common in poured concrete. Width, direction, offset and signs of ongoing movement are what decide whether a crack should be reported as a concern.

Should an inspector say whether a house is structurally sound?

No. A general inspection is visual and limited. Describe what you observed and recommend a structural engineer when the clues suggest movement or damage.

What if the crawlspace cannot be entered?

Report that it was not entered, the reason, and what was viewed from the access point, so the client knows the limitation.

Ready for timed practice? Try the free sample or see study plans.

Educational study aid only. Independent of the Examination Board of Professional Home Inspectors and any testing vendor. Crawlspaces, attics and damaged structures can be hazardous; leave evaluation and repairs to licensed professionals and follow your state's standards of practice. No exam outcome is promised.

Related: How to become a home inspector · Home inspector exam tips · How hard is the home inspector exam? · Home inspector licensing requirements: a state overview · Texas home inspector license overview · Florida home inspector license overview · California home inspector rules overview · A 30-day study plan for the home inspector exam · How to use a home inspector practice test · How long does it take to become a home inspector? · Roof inspection basics for the exam · Electrical inspection basics for the exam · Plumbing inspection basics for the exam · Heating and cooling inspection basics for the exam · Report writing and professional practice for the exam · Life safety inspection basics for the exam · Interior and fireplace inspection basics for the exam · Attic insulation and ventilation basics for the exam · Exterior and site inspection basics for the exam · Home inspector exam day checklist · Is home inspection a good career?